MEWP.guide
Genie S-40 TraX shown in its official manufacturer specification

Your browser cannot display the PDF inline.

Open the specification PDF
Original specification · page 1

Telescopic BoomManufacturer country: United States

S-40 TraX

14.04 m working height, 9.47 m outreach, 300 kg platform capacity.

Working height
14.04 m
Max outreach
9.47 m
Basket capacity
300 kg
Transport width
2.49 m
Transport length
8.03 m
Power
Diesel
Configuration-dependent valuesRead the capacity and reach note ↓
DieselTrackedTelescopic Boom Lift
Open PDFSource

Primary manufacturer source

Specification PDF

Open full screen
Official specificationPrimary sourceFull screen

Your browser cannot display the PDF inline.

Open the specification PDF
Original specification - page 1

Normalized data

Specifications

Empty fields are omitted

Working envelope

Working height
14.04 m
Horizontal outreach
9.47 m

Capacity

Safe working load
300 kg

Dimensions

Machine width
2.49 m
Machine length
8.03 m

Mobility

Drive
Tracked

Power

Power source
Diesel

Before use

Safety & operating limits

Risk assessment

Complete a site-specific risk assessment and rescue plan before work starts.

Working envelope

Confirm outreach at the intended basket load, slew angle, stabilizer position and chassis configuration.

Wind conditions

Check the applicable wind rating in the current manufacturer manual and stop work when limits are exceeded.

Competent selection

Verify ground conditions, outrigger loads, access, exclusion zones and operator requirements with a competent supplier.

Model questions

Genie S-40 TraX FAQ

What is the working height of the Genie S-40 TraX?

The published working height is 14.04 m. Working-height conventions can vary by market and configuration, so confirm the applicable manufacturer document before use.

How much horizontal outreach does the S-40 TraX have?

The published maximum horizontal outreach is 9.47 m. Outreach can reduce with basket load, slew angle, stabiliser position and optional equipment.

What is the platform capacity of the S-40 TraX?

The listed safe working load is 300 kg. Confirm whether that capacity applies throughout the required working envelope and configuration.

How wide is the S-40 TraX?

The listed transport width is 2.49 m. Check the complete stowed envelope, mirrors, stabilisers, tyres or tracks and the route clearance before transport or setup.

What powers the S-40 TraX?

This machine is listed as diesel powered. Confirm the exact power configuration and charging or refuelling requirements in the source document.

What transport dimensions should be checked for the S-40 TraX?

The published transport dimensions include a length of 8.03 m. Confirm the complete configured envelope before loading, towing or entering a site.

Where can the S-40 TraX be used?

The catalogue flags this telescopic boom for outdoor use. Site conditions, wind limits, ground bearing capacity and the manufacturer's operating instructions still determine suitability.