MEWP.guide
Bronto S50 XDT-J from the supplied specification document

Your browser cannot display the PDF inline.

Open the specification PDF
Original specification · page 1

Truck MountedManufacturer country: Finland

S50 XDT-J

49.5 m working height, 35.4 m outreach, 600 kg platform capacity.

Working height
49.5 m
Max outreach
35.4 m
Reach below deck
10 m
Basket capacity
600 kg
Vehicle weight
26,000 kg
Stowed height
3.8 m
Transport width
2.5 m
Transport length
11.9 m
Power
Diesel
Configuration-dependent valuesRead the capacity and reach note ↓
RoadArticulatedDieselTruck
Open PDFSource

Primary manufacturer source

Specification PDF

Open full screen
Official specificationPrimary sourceFull screen

Your browser cannot display the PDF inline.

Open the specification PDF
Original specification - page 1

Normalized data

Specifications

Empty fields are omitted

Working envelope

Working height
49.5 m
Horizontal outreach
35.4 m
Vertical reach down
10 m

Capacity

Safe working load
600 kg

Dimensions

Machine width
2.5 m
Machine length
11.9 m
Stowed height
3.8 m

Weight

Machine weight
26,000 kg

Mobility

Drive
Road

Power

Power source
Diesel

Before use

Safety & operating limits

Risk assessment

Complete a site-specific risk assessment and rescue plan before work starts.

Working envelope

Confirm outreach at the intended basket load, slew angle, stabilizer position and chassis configuration.

Wind conditions

Check the applicable wind rating in the current manufacturer manual and stop work when limits are exceeded.

Competent selection

Verify ground conditions, outrigger loads, access, exclusion zones and operator requirements with a competent supplier.

Model questions

Bronto Skylift S50 XDT-J FAQ

What is the working height of the Bronto Skylift S50 XDT-J?

The published working height is 49.5 m. Working-height conventions can vary by market and configuration, so confirm the applicable manufacturer document before use.

How much horizontal outreach does the S50 XDT-J have?

The published maximum horizontal outreach is 35.4 m. Outreach can reduce with basket load, slew angle, stabiliser position and optional equipment.

What is the platform capacity of the S50 XDT-J?

The listed safe working load is 600 kg. Confirm whether that capacity applies throughout the required working envelope and configuration.

How wide is the S50 XDT-J?

The listed transport width is 2.5 m. Check the complete stowed envelope, mirrors, stabilisers, tyres or tracks and the route clearance before transport or setup.

How much does the S50 XDT-J weigh?

The listed machine weight is 26,000 kg. Actual transport weight may vary with chassis, fuel, batteries, basket and optional equipment.

What powers the S50 XDT-J?

This machine is listed as diesel powered. Confirm the exact power configuration and charging or refuelling requirements in the source document.

What transport dimensions should be checked for the S50 XDT-J?

The published transport dimensions include a length of 11.9 m and a stowed height of 3.8 m. Confirm the complete configured envelope before loading, towing or entering a site.

Where can the S50 XDT-J be used?

The catalogue flags this truck mounted for outdoor use. Site conditions, wind limits, ground bearing capacity and the manufacturer's operating instructions still determine suitability.